Faststeel Steel-reinforced epoxy putty stick

Faststeel Steel-reinforced epoxy putty stick 1.The ultimate solution for small or emergency repairs 2.Easy-to-use and mistake

Faststeel Steel-reinforced epoxy putty stick

Product Description:

FastSteel is a hand-mixable, non-rusting, steel-reinforced epoxy

putty that quickly repairs or rebuilds anything made of steel.

After mixing, it forms an industrial-strength polymer compound

that can be molded into shapes or used to build up, patch and

repair steel components. Each handy stick contains pre-measured

portions of activator and base throughout — no measuring or

mixing tools are necessary. The consistency (like modeling clay)

eliminates drips and runs and facilitates adhesion to the substrate.

After 60 minutes the application can be drilled, tapped, ground,

machined, filed, and painted. FastSteel cures to a dark gray metallic

color. Suitable for interior or exterior use, it is resistant to water,

chemicals, and temperature extremes. FastSteel contains no VOCs

or solvents. It's non-flammable and releases no noxious fumes. It

won't shrink or pull away. The unused portion stays fresh for future

use when saved in its original package.

Performance Data:

SHELF LIFE AT 75°F (24°C), minimum 24 months

SHORE D HARDNESS AT FULL CURE (24 hrs) 80

LAP SHEAR TENSILE STRENGTH

On steel (1" x 1" x 1/16") 900 lbs (6.2 MPa)

COMPRESSIVE STRENGTH 8,000 psi (55 MPa)

DENSITY 18.5 lb/gal, 2.2 gm/cm3

SHRINKAGE <1%

NON-VOLATILE CONTENT 100%

ELECTRICAL RESISTANCE 30,000 megohms

DIELECTRIC STRENGTH 300 volts/mil

UPPER TEMPERATURE LIMITS

Continuous 250°F (121°C)

Intermittent 300°F (149°C)

CHEMICAL RESISTANCE

Resistant to hydrocarbons, ketones, alcohols, esters,

halocarbons, aqueous salt solutions and dilute acids

and bases.

How to use :

Before applying ,roughen and clean the area to be repaired .then follow these easy steps.

1.cut or twist off repaired amount

2.mix by kneading with fingers to a uniform color .if mixing is difficult ,warm Faststeel to room temperature or slightly above.

3.apply to surface to be repair within 2 minutes of mixing .force into any cracks or holes and strike off excess material,preferably with a tool moistened with clean water.

 

When applying to a damp, wet or slowly leaking area,work the mixed material forcefully into the surface and apply pressure until adhesion begins to take effect.

 

For best results:use damp fingers for easier mixing,application,and smooth appearance of the cures compound.remove excess material before hardening begins.

 

Curing:Faststeel has a 3-to-5 minute work life .Functional cure occurs in 60 minutes.

Faststeel Steel-reinforced epoxy putty stick